System Specifications

Tightening Specifications
Anti-Roll Bar Nut (In Wishbone) 40-54 Nm (30-40 ft. lbs.)
Differential Bearing Retainer 20-28 Nm (15-21 ft. lbs.)
Drain Plug 45-55 Nm (33-41 ft. lbs.)
End Cover Screws 20-28 Nm (15-21 ft. lbs.)
Engine To Transmission 50-90 Nm (35-65 ft. lbs.)
Inner Gear Mechanism Screws 20-28 Nm (15-21 ft. lbs.)
Gearbox Protection Plate 50-90 Nm (35-65 ft. lbs.)
Gear Case/Clutch Case:
Parting Surface 20-28 Nm (15-21 ft. lbs.)
Input Shaft Bearing Retainer 33-43 Nm (24-32 ft. lbs.)
Level Plug 40-60 Nm (29-45 ft. lbs.)
Output Shaft Bearing Retainer 33-43 Nm (24-32 ft. lbs.)
Reverse Gear Lever Screws 20-28 Nm (15-21 ft. lbs.)
Reverse Light Switch 20-28 Nm (15-21 ft. lbs.)
Selector Shaft Carrier Screw 20-28 Nm (15-21 ft. lbs.)
Subframe:
Front Mounting 43-57 Nm (32-43 ft. lbs.)
Rear Mounting 47-63 Nm (35-47 ft. lbs.)