Mirror Turn Signal Lens Replacement

Mirror Turn Signal Lens Replacement

Removal Procedure




1. Carefully move the outside rearview mirror (ORVM) assembly forward in order to gain access to the lens retaining screw (1) located underneath the assembly, near the pivot point.
2. Remove the lens retaining screw.
3. Remove the lens from the ORVM assembly.




4. Remove the socket and the lamp from the lens by turning the socket counterclockwise.
5. If replacing the bulb, remove the bulb from the socket.

Installation Procedure




1. If replacing the bulb, install the bulb to the socket.
2. In order to install the socket to the lens, index the socket retaining tabs to the lens and turn the lens clockwise until fully seated.




3. Position the lens to the ORVM assembly
4. Install the lens to the ORVM assembly.

Notice: Refer to Fastener Notice (Fastener Notice).

5. Install the lens retaining screw (1).

Tighten the screw to 1 Nm (8 in. lbs.).

6. Return the mirror assembly to the original position.