Vehicle Speed Sensor: Service and Repair

REMOVAL

1. Position vehicle on lift and raise car.


2. Disconnect electrical connector from speed sensor and remove sensor.



INSTALLATION

IMPORTANT: Inspect O-ring for damage and replace if necessary.

1. Install speed sensor.


Torque: 26 Nm (20 ft lbs)


NOTICE: Clean and lubricate fastener with ATF (DEXRON-II or DEXRON-III). Wipe off excess fluid and install.


2. Connect electrical connector to speed sensor. Push in until a click is heard and pull back to confirm positive engagement.


3. Lower vehicle.


4. Check transaxle fluid level.