Circuit Testing - Grounds

Before checking the ground circuit from the faulty component all the way to the ground stud, check the circuit from the splice pack to ground by testing some of the other subsystems grounded by the same splice pack. If the other subsystems function properly, it is most likely that the path from the splice pack to ground is good (or at least one of the paths is good with redundantly grounded splice packs).

I/P Splice Pack #2


Location: Taped to harness behind I/P cluster.


The Systems grounded by I/P splice pack #2 are grounded redundantly with I/P splice pack #1 at ground point location D (I/P chassis ground). If one of the following systems is operating normally, the ground circuit is most likely good.

^ Fuel sensor

^ Park brake switch

^ Wiper motor

^ Radio

Check for OPENS/SHORTS.


Repair as needed.


If this component is good, go to the next item indicated on the "Complaint-Condition" chart.


Circuit 35OL/3SOZ


Location: Connects radio connector cavity 5 to I/P ground splice pack cavity D to I/P chassis ground D.


Type: Black 16 gage wire


Function: These circuits provide ground for the radio.


Check for OPENS/SHORTS.


Repair as needed.


If this component is good, go to the next item indicated on the "Complaint-Condition" chart.