1991-1995 Coupe and Sedan

IMPORTANT:
On certain 1991 - 1995 vehicles the BLK and WHT handle wires may need to be lengthened using same gage wire.





1. Route handle ORN wire over to latch area.

2. Cut existing latch connector off and splice the following wires together using splice sleeves supplied with kit.:

^ On 1991-1994 vehicles, splice together handle ORN wire, existing latch ORN wire, and existing latch LT GRN wire.

^ On 1995 vehicles, splice together handle ORN wire, existing latch ORN wire, and existing latch RED/BLK wire.

3. Secure all connections and wire with tape to prevent damage to wires.

IMPORTANT:
Extra 3-way black connectors and WHT wires may be supplied with kit and will not all be used.

4. Using one black 3-way connector (P/N 12047781) and one WHT wire (P/N 12112316) supplied with kit, insert WHT wire into cavity C of black 3-way connector body.

5. Connect the black 3-way connector to latch assembly.

6. Route handle WHT wire over to latch connector.





7. Cut to length and splice handle WHT wire and remaining length of handle WHT wire to jumper WHT wire coining from cavity C of the black 3-way connector.

8. Wrap entire length of handle wiring harness with tape to prevent damage to wires.

9. Route handle BLK wire and remaining length of handle WHT wire along existing decklid harness over to bottom of decklid hinge.

10. Insert handle wires into existing clips along decklid harness.

11. Place WHT and BLK handle wires in approximately three feet of conduit (P/N 21023494) and route them along bottom of rear window panel over to cargo lamp area.





12. Remove cargo lamp housing and disconnect cargo lamp if needed.

13. Cut cargo lamp BLK wire in half allowing enough room for splices.

14. Splice handle WHT wire to one cargo lamp BLK wire using splice sleeves supplied with kit.





15. Splice handle BLK wire to other cargo lamp BLK wire using splice sleeves supplied with kit.

16. Tape and secure all wires to prevent damage due to sharp metal edges.

17. Connect cargo lamp connector and install cargo lamp housing if removed.

15. Install 10A BODY fuse in instrument panel fuse block.