Sunroof Glass Panel Replacement

SUNROOF GLASS

REMOVAL

1. Power the sunroof to the VENT position.

2. Remove screws attaching sunroof glass to guide assemblies, lift glass out of roof opening.

NOTICE: Do not cycle sunroof to fully closed position without glass being installed or damage to guide assemblies will occur.

INSTALLATION

1. With guide assemblies in vent position, position sunroof glass onto guide assemblies and align mounting holes.

2. Apply Loctite Small Screw Threadlocker 222 (or equivalent) to sunroof glass attaching screws and install them, proceeding to the next step before tightening.

3. With sunroof in closed position, adjust sunroof glass to 1 mm (0.04 in.) below roof surface at front of glass and 1 mm (0.04 in.) above roof surface at rear of glass and tighten sunroof glass attaching screws.

Torque: 4-5 Nm (35-44 in-lbs)