Removal/Installation

Fig. 7 Belt Spring Tension Release.:

1. Remove power steering pump reservoir fill cap.
2. Raise and support vehicle.
3. Place a drain pan below steering gear hoses.
4. Remove steering gear hoses and allow system to drain. Do not rotate steering wheel.
5. Using a box end wrench, relieve spring tension from accessory drive belt, then remove belt, Fig. 7.
6. Remove pump to intake manifold bracket, then pump to engine block bracket.
7. Remove pump to engine block attaching bolts, then raise pump to disconnect EVO electrical connector.
8. Remove pump and hose assembly, then remove hoses.
9. Reverse procedure to install.