Transaxle Case Disassemble

1. Using suitable screwdriver, remove right case side axle seal dust cover, then remove seal retaining ring, install seal removal tool No. SA9113T or equivalent, through steel seal body as close to outside diameter as possible, then remove seal.

2. Using suitable screwdriver, remove selector switch seal.

3. Using suitable snap ring pliers, expand input and output shaft bearing snap rings enough to slide bearings from bore by hand.

4. Remove reverse idler assembly as follows:

a. Remove reverse idler gear shaft




b. Cap bolts. Remove cap.

c. Remove idler gear shaft. Shaft contains O-rings, rotate shaft while pulling to remove.

d. Remove gear and bearing.