Valve Body Replace

REMOVAL

1. Disconnect battery terminals; Disconnect ground terminal first.

2. Remove battery shield, then battery.

3. Remove battery tray.

4. Loosen transaxle connector bolt, then disconnect electrical connector.

5. On models equipped with ABS, remove master cylinder to booster attaching nuts, then lift cylinder slightly to remove valve body cover, then position cylinder back on booster studs.

6. Remove valve body cover attaching bolts.




7. Remove eleven valve body to case bolts as shown.


INSTALLATION

1. Install manual valve to manual link with manual valve flat facing upwards.

2. Lower valve body, then install manual link to manual valve.




3. Valve body to case attaching bolts must be install to valve body prior to installation.

4. Clean and lubricate attaching bolts with Dexron II, or equivalent.




5. Tighten valve body bolts in sequence to specifications.




6. Tighten valve body to case attaching bolts in sequence to specifications.




7. Using suitable carburetor cleaner, clean valve body cover gasket surface, then install valve body cover attaching bolts in sequence and tighten to specifications.

8. On models equipped with ABS, install master cylinder to booster attaching nuts, then tighten to specifications.

9. Connector transaxle electrical connector, then tighten connector attaching bolt to specifications

10. Install battery tray, then tighten attaching bolts to specifications.

11. Install battery and battery shield attaching bolts, then tighten to specifications.

12. Connect battery terminals. Connect positive terminal first to prevent arcing.