Operation CHARM: Car repair manuals for everyone.

Lock Rods and Door Handle Rods






REMOVAL

1. Remove outer door panel.
2. Cycle glass to full up position.
3. Remove rods as required.

INSTALLATION

NOTICE: The rod retaining clips used in the door lock levers and door lock cylinder pawls are not re-useable. Retention characteristics are minimized once a rod is extracted. Clips must be replaced every time a rod is extracted.

1. Install lock rods and/or door handle rods.
2. Outside door handle rod length should be adjusted so associated lock lever is in a relaxed state.
3. Replace outside door panel.