Side Closing Plate

SIDE CLOSING PLATE - WAGON






NOTE: The side closing plate has structural weld-through adhesive in the joint areas. It is necessary to replace this with additional spot welds at the attachment points. This can be accomplished by adding an additional weld between each factory weld in all areas.

1. Note amount and location of spot welds.
2. Remove sealer and drill spot welds from:
a. Rear body panel assembly.
b. Floor pan assembly.
c. Body side inner.

NOTE: Clean all weld seams with a wire brush, prime and seal all repair areas. Apply permanent underbody sealant. It is important that proper corrosion protection processes are used on all repair areas. Prime with two-part catalyzed primer. Apply sealers and corrosion protection materials according to information in the Body Paint section or paint manufacturer's recommendations.

3. Install closing plate, align, clamp, and weld into place.