Output Shaft Clearance Measurement

NOTICE: The 5th driven gear has an identifier groove marked on its face. Install the gear with the groove facing up.





1. Assemble output shaft with 5th driven gear as shown. Use old nut and torque.
- Torque: 150 Nm (110 ft. lbs.)





2. Measure clearance between 3rd/4th cluster gear and 2nd driven gear.
Clearance:
Standard: 0.20 mm - 0.35 mm (.008 inch - .014 inch)
3. Measure clearance between 1st driven gear and 1st driven gear thrust washer.
Clearance:
Standard: 0.20 mm - .0495 mm (.008 inch - .019 inch)