Manual Valve Link

REMOVAL





1. Remove valve body.

NOTICE: If manual shift shaft is rotated excessively, internal damage to the transaxle range switch may occur.

2. Remove the nut retaining the manual detent lever to the manual shift shaft.

IMPORTANT: Place a clean rag in the transaxle case under the manual detent lever to catch the nut in case it is dropped.

3. Remove the manual detent lever from the manual shift shaft and disengage the park pawl lever from it.
4. Remove the manual detent lever and the manual valve link from the transaxle.

INSTALLATION
1. Install the manual valve link to the manual detent lever.
2. Attach the park pawl link to the manual detent lever and install it on the manual shift shaft.

NOTICE: If manual shift shaft is rotated excessively, internal damage to the transaxle range switch may occur.

3. Prevent the manual shift shaft from rotating by holding control lever.
4. Install the attachment nut and torque.
- Torque: 12 Nm (9 ft. lbs.)
5. Remove the rag from the transaxle case.
6. Install the valve body.