P1584
The cruise control system can be disabled due to a number of conditions that may or may not set DTC P1584. Under a properly working cruise control system, normal driver commands such as turning the cruise control switch Off or depressing the brake pedal will NOT set this DTC. However, the driver may induce this DTC if the gear shift lever is placed in neutral while cruise is engaged. DTC P1584 sets when the PCM disables cruise control because any one of the following conditions listed under DTC parameters occurred while in cruise control mode.
DTC Parameters
DTC P1584 will set if the PCM disables the cruise control clutch due to any of the following conditions occurring while in cruise control mode:
^ Gear position is out of range (trans range switch indicates P, R, N, or 1st) A/T only
^ Transaxle range switch position is invalid (A/T only)
^ Cruise set speed is greater than 161 km/h (100 mph) or less than 40 km/h (25 mph)
^ Vehicle speed is less than 32 km/h (20 mph)
^ Engine speed is less than 950 RPM or greater than 6500 RPM
^ Traction control is active
^ Vehicle acceleration is greater than 16 km/h/second (10 mph/second)
^ Vehicle deceleration is greater than 6.5 km/h/second (4 mph/second)
^ Cruise set speed differs from actual vehicle speed by greater than 24 km/h (15 mph) for 10 seconds or greater than 32 km/h (20 mph) instantaneously
^ Ignition voltage is less than 10 volts or greater than 16 volts
^ Engine coolant temperature is greater than 118°C (244°F) (overheat condition)
DTC P1584 diagnostic runs continuously in cruise control mode.
DTC P1584 is a type D DTC.
Diagnostic AIDS
Use Scan tool Failure Record information to help diagnose driver induced cruise disable vs. cruise disable due to a system failure. Inspect the DISABLE BITS located toward the bottom of the Failure Record to determine the cause.
Make sure no transaxle range switch DTCs are present (A/T only). Diagnose those DTCs first if any are set.
Make sure VEHICLE SPEED reads correctly on Scan tool and that no VSS DTCs are present. Make sure SPEED NOISE = NO under the transmission data display table (A/T only) while the vehicle is driven. This will indicate if an intermittent vehicle speed sensor circuit fault is occurring.