Operation CHARM: Car repair manuals for everyone.

Component Tests and General Diagnostics

Idle HC/CO Concentration Check


Diagnostic Chart:






IMPORTANT: This check is used only to assist with idle HC/CO Diagnostics.

^ Initial Conditions:
- Engine must reach normal operating temperature.
- Air cleaner installed.
- All pipes and hoses of air induction system connected.
- All vacuum lines properly connected.
- All fuel system wiring connections fully plugged.
- Transmission in P (Park) or N (Neutral) range.
- Tachometer and HC/CO meter calibrated and in hand.
^ Run engine at 2,500 rpm for approximately two minutes.
^ Insert HC/CO meter testing probe into intermediate pipe at least 40 cm (16 in.).
^ Check HC/CO concentration at idle.

IMPORTANT: Wait at least one minute before measuring to allow the concentration to stabilize. Complete the measuring within three minutes. If the HC/CO concentration does not conform, see the following HC/CO diagnostic chart for possible causes.