Fuel Tank Draining Procedure On the Hoist

TOOLS REQUIRED
^ SA127E-7 Fuel Flow/Pressure Adapter
^ 7000081-SAT3 ScanTool

1. Remove air cleaner inlet tubing from throttle body.

NOTE: Fuel supply lines will remain pressurized for long periods of time after the engine is shutdown. This pressure must be relived before servicing the fuel system.

2. Connect Scan tool to vehicle diagnostic connector, turn ignition On.
3. Relieve pressure in fuel system at fuel pressure test port (refer to "Relieving Fuel Pressure"). Service and Repair
4. Raise vehicle on hoist to comfortable working height, keeping Scan tool outside of vehicle and accessible from under car.

CAUTION: Whenever fuel line fittings are loosened or removed, wrap a shop cloth around the fitting and have an approved container available to collect any fuel.




5. Disconnect fuel feed line at inlet to filter/regulator (5/16 in. line).




6. Install 5/16" x 1/4" quick connect (1) adapter from flow/pressure adapter (SA9127E-7) into fuel feed line, connect suitable drain hose to other end of adapter, and connect drain hose to certified fuel handling cart
7. Energize the fuel pump using the Scan tool (refer to "Energizing the Fuel Pump"). Energizing the Fuel Pump
8. Pump out all fuel (or until no more than 1/4 tank remains).