Automatic Transmission - Resetting Adaptive Parameters

Because the PCM has the ability to adapt to various transaxle conditions, it is necessary to reset the adaptive parameters after certain repairs have been performed. The adaptive can be reset using the Saturn Service Stall (SSS) or using a Scan tool. The adaptive should only be reset after the following repairs have been made:
- Replacing a transaxle.
- Replacing a TCC or PC solenoid.
- Transaxle overhaul when new clutch plates are installed.
- Replacing a valve body.
- Replacing the PCM for a transaxle related failure.

IMPORTANT: When replacing the PCM for an engine related problem the transaxle adaptive should be transferred from the old PCM to the new PCM.

After performing a repair, the vehicle must be driven to allow the adaptive to learn new shift times and pressures before returning the vehicle to a customer. Refer to Learn-In procedure below.

LEARN-IN PROCEDURE
If one of the repairs mentioned has been performed, then the adaptive should be reset using the SSS or using a Scan tool. Also, the vehicle must be driven, preferably on a highway, according to the following steps. By following these steps, the adaptive will be properly learned prior to returning the vehicle to the customer.
1. Warm up transaxle (fluid temperature above 45°C [113°F]).
2. Perform 10 sets of upshift (1-2, 2-3, 3-4) at 30% throttle:
- For DOHC Engine
a. While coasting at 56 km/h (35 mph) slowly accelerate to half throttle to achieve a 4-3 downshift.
b. With selector in D3 while coasting at 32 km/h (20 mph) slowly accelerate to 75% throttle to achieve a 3-2 downshift.
Repeat both procedures five times.
- For SOHC Engine
a. While coasting at 64 km/h (40 mph) slowly accelerate to half throttle to achieve a 4-3 downshift.
b. With selector in D3 while coasting at 48 km/h (30 mph) slowly accelerate to one half throttle to achieve a 3-2 downshift.
Repeat both procedures five times.