Operation CHARM: Car repair manuals for everyone.

Output Shaft Roller Bearing

- TOOLS REQUIRED
- SA9191T M/T Case Output Shaft Bearing Puller
- SA9173G Slide Hammer
- SA9133T Axle Seal Puller

REMOVAL





1. Remove bearing retaining ring.
2. Install bearing removal tool SA919lT and tighten securely in bearing.
3. Install slide hammer SA9173G to bearing puller. Place housing, bearing side down, on a press stand. Use slide hammer to remove bearing. Use wood blocks on sealing surface to protect machined surfaces.





4. Remove transaxle lubrication funnel (oil baffle plate).
5. Remove output shaft bearing filter. Thread a rear cover bolt into the filter and pull filter out.
6. Remove stake if necessary.
7. Remove right axle seal using SA9133T.