Output Speed Sensor

OUTPUT SPEED SENSOR (OSS)

CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.

REMOVAL
1. Position vehicle on hoist and ensure ignition is Off.
2. Raise vehicle.





3. Disconnect Output Speed Sensor (OSS) harness connector and remove.

INSTALLATION

IMPORTANT: Inspect O-ring for damage and replace if necessary.

IMPORTANT: Clean and lubricate fastener with Saturn Transaxle Fluid. Wipe off excess fluid.

1. Install OSS.
Torque:
Output Speed Sensor (OSS): 26 Nm (19 ft. lbs.)
2. Connect OSS harness connector. Push in connector until a click is heard and pull back to confirm a positive engagement.
3. Lower vehicle.
4. Check transaxle fluid level.