PASSLOCK - Saturn Service Stall Method

Saturn Service Stall Method

^ This method takes about 10 minutes for programming.
^ A programming system is required.
^ A Scan tool is required.

The following shows when the relearn procedure needs to be performed.

CONTROLLER REPLACED:
BCM:
1. The new service BCM will automatically learn the voltage code from the Passlock sensor.
2. Password from the BCM to the PCM/ECM requires the Saturn Service Stall to learn the new password in order to enable fuel and start the vehicle. Initiate the 10-minute relearn procedure.
3. RKE transmitters will carry over from the previous BCM when using the Saturn Service Stall System.

PCM: (4 cylinder)
1. The Saturn Service Stall System will be required, initiate the 10-minute relearn for the fuel enable password from the existing BCM.

ECM: (6 cylinder)
1. The Saturn Service Stall System will be required, initiate the 10-minute relearn for the fuel enable password from the existing BCM.

TCM: (6 cylinder)
1. No relearn required for controller replacement.

Passlock Sensor (Ignition Module)
1. The Saturn Service Stall will be required to initiate the 10-minute relearn procedure for the existing BCM.

IMPORTANT: If the BCM or PCM are not new replacement parts, the relearn procedure must be performed. Using a module from another vehicle requires the relearn procedure to be performed.