Evacuating the System

1. Connect manifold gauge set and vacuum pump to high and low side service ports. Turn on vacuum pump and slowly open high and low side service valves to pump. Allow system to evacuate for 20 - 30 minutes. Note vacuum gauge reading.
2. Close high and low side service valves. Shut off vacuum pump.
3. Watch low side gauge for vacuum loss (one to three minutes).
^ If loss is less than 3.38 kPa (1 in. Hg) from level recorded in Step 1 proceed to charging the A/C system.
^ If vacuum loss is greater than 3.38 kPa (1 in. Hg) from level recorded in Step 1, charge with 0.23 kg (0.5 lb.) R-134a. Leak test, repair leaks, and re-test.

IMPORTANT: Disconnect high side service valve from service port and check for vacuum loss before leak testing.