Instrument Panel (IP) - Trim Panel Replacement - Upper

REMOVAL




1. Remove fasteners located under upper trim panel on passenger side of vehicle.

NOTE: Be careful not to damage VIN plate when removing or replacing upper trim panel.

2. Disengage clips at locations by grasping edges of upper trim panel and lifting up.
3. Disengage hook-and-loop fastener attachments at rear of upper trim panel by reaching under panel and lifting straight up.
4. Raise upper trim panel enough to clear VIN plate.

INSTALLATION

NOTE: Be careful not to damage VIN plate when removing or replacing upper trim panel.

IMPORTANT: Be sure upper trim panel seal is correctly seated on forward edge before installing upper trim panel.




1. Ensure hook-and-loop fastener attachments on upper trim panel are correctly inserted.
2. Position upper trim panel on retainer assembly.
3. Align tabs on sides of upper trim panel with openings in windshield garnish molding.
4. Align clips and clip location.
5. Firmly snap in clips at clip locations.
6. Install fasteners on underside of upper trim panel on passenger side of vehicle.

Torque:
I/P Upper Trim Panel Fasteners: 6 N.m (53 in-lbs)