Scan Tool Usage With Intermittents

In some Scan tool applications, the data update rate makes the tool less effective than a voltmeter, such as when trying to detect an intermittent problem which lasts for a very short time. However, the Scan tool does allow one to manipulate wiring harnesses or components under the hood with the engine not running, while observing the readout of the Scan tool.

Scan tool data display can be observed while driving the vehicle under the condition when the Malfunction Indicator Lamp (MIL) or the SERVICE telltale turns On momentarily or when engine driveability is momentarily poor. An assistant should be used when driving a vehicle and using a Scan tool. If the problem seems to be related to certain parameters that can be checked on the Scan tool, they should be checked while driving the vehicle. If there does not seem to be any correlation between the problem and any specific circuit, the Scan tool can be checked at different conditions, watching for a period of time to see if there is any change in the readings that would indicate an intermittent problem.

The Scan tool is also an easy way to compare the operating parameters of a poorly operating engine with those of a known good one. For example, a sensor may shift in value, but not set a diagnostic trouble code. Comparing sensor readings with those of a known good vehicle may uncover the problem.

The PCM has the ability to take a snapshot when a diagnostic trouble code is stored. This information can be found with a Scan tool listed under Failure Record information. This information can be very useful when attempting to troubleshoot intermittent diagnostic trouble codes.

The "customer snap-shot" feature can also be used for intermittents. Refer to DTC P1624 for explanation. P1624