2. End Cover

TOOLS REQUIRED
- SA9136T Hub Seal Expander Sizer Kit
- SA9143T Input Shaft Seal Installer

DISASSEMBLY

IMPORTANT: Remove and install parts carefully to avoid damage.

1. Remove output shaft hub lip seal retainer and remove lip seal.
2. Remove output shaft hub retainer and remove output shaft hub.
3. Remove two input shaft hub retaining bolts and remove hub.





- On 1st design, remove external bolts from end cover.
1ST DESIGN SHOWN.





- On 2nd design, remove internal Torx bolts from inside the input shaft hub.
2ND DESIGN SHOWN.

4. Separate the input tube from the input shaft hub and separate the output shaft tube from the output shaft hub by pressing the tubes out of the hubs by hand.





5. Inspect all seals and O-rings for damage. Replace as necessary.