Operation CHARM: Car repair manuals for everyone.
Home >> Saturn >> 2002 >> SC2 L4-1.9L DOHC VIN 7 >> Repair and Diagnosis >> Transmission and Drivetrain >> Drive Axles, Bearings and Joints >> Axle Shaft Assembly >> Service and Repair >> Deflector Ring - Left Axle Shaft

Deflector Ring - Left Axle Shaft

DEFLECTOR RING - LEFT AXLE SHAFT

- TOOLS REQUIRED
- J44280 Axle Shaft Deflector Ring Installer

NOTICE: The axle shaft deflector ring is designed to aid the transaxle seal from dirt and water intrusion. Deflector rings are installed on left and intermediate axle shafts, and rotate around the third lip of the transaxle seals. Improperly installed deflector rings may cause premature failure of transaxle seals, deflector rings, and axle shafts. Special tools J44280-1 and J44280-2 are required to properly install the deflector rings.

IMPORTANT: If an axle shaft deflector ring is removed, a new deflector ring must be installed. Do not re-use axle shaft deflector rings that have been previously installed. If an axle shaft deflector ring is damaged, it should be replaced. Do not attempt to repair damaged deflector rings.

REMOVAL
1. Remove axle assembly(s) from vehicle.

NOTICE: Do not damage the smooth portion of the axle shaft assembly. The transaxle seal rides upon the smooth portion. If damaged, a leak can occur.





2. Clamp axle shaft assembly in a vice. Use soft metal or wood between vice jaws to protect the shaft.








3. Remove axle shaft deflector ring by prying off with a screwdriver, or gently tap off with a soft mallet.
4. Discard axle shaft deflector ring. A new axle shaft deflector ring will be required for installation.

INSTALLATION
1. Inspect axle shaft assembly for any damage, repair as necessary.
2. Thoroughly clean area that deflector ring is to be installed upon.

IMPORTANT: Be sure to notice which direction the deflector ring is installed. Cupped end of deflector ring should face towards the transaxle seal.





3. Slide deflector ring onto drive axle shaft assembly by hand.

IMPORTANT: The deflector ring must be fully seated against the tri-pot housing. If not fully seated, the deflector ring may cause premature failure to the transaxle seal.

4. Use special tool Axle Shaft Deflector Ring Installer J44280-2 to install axle deflector ring remainder of the way. The deflector ring should bottom out against the tri-pot housing.
5. Install drive axle assembly into vehicle.
pro multis · About Operation CHARM