Body Control Module: Service and Repair
BODY CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
IMPORTANT: Service programming is required when replacing the BCM. Refere to "Saturn Service Stall" user's guide.
1. Remove the radio bezel.
2. Disconnect the body control module (BCM) electrical harnesses.
3. Remove the BCM from the I/P retainer:
1. Pry the BCM tabs from the locking tabs on the underside of the restraint.
2. Slide the BCM out of the retainer.
INSTALLATION PROCEDURE
1. Install the BCM.
2. Install the radio bezel.
3. Slide the BCM tabs into the slots in the I/P retainer until the tabs lock into place.
4. Connect the electrical connectors.
5. Program a new or a remanufactured BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration. Programming and Relearning