Operation CHARM: Car repair manuals for everyone.
Home >> Saturn >> 2004 >> ION L4-2.2L VIN F >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Engine Control Module: Service and Repair

ENGINE CONTROL MODULE (ECM) REPLACEMENT

REMOVAL PROCEDURE

NOTE:
- In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins or the soldered components on the circuit board.
- Always turn the ignition off when installing or removing the ECM connectors in order to prevent damage to the components.

1. Disconnect the negative battery cable.




2. Disconnect the small ECM harness connector (3) from the ECM.
3. Remove the bolt retaining the large ECM connector to the ECM.
4. Disconnect the large ECM harness connector (4) from the ECM.




5. Use the retaining tab to release the ECM from the underhood junction block bracket.

INSTALLATION PROCEDURE




1. Use the retaining tab to secure the ECM, when installing the ECM to the underhood junction block bracket.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Connect the large ECM harness connector (4) to the ECM.

Tighten the bolt to 4 N.m (35 lb in).

3. Connect the small ECM harness connector (3) to the ECM.
4. Connect the negative Battery Cable.
5. Program the ECM. Refer to Service Programming System (SPS) in Programming. Programming and Relearning
pro multis · About Operation CHARM