63. Intake Plenum Installation

Intake Plenum Installation





1. Install the throttle body gasket to the plenum.
2. Install the throttle body to the plenum.

Notice: Refer to Fastener Notice in Service precautions.

3. Install the throttle body nuts.
^ Tighten the throttle body nuts to 8 Nm (71 inch lbs.).





4. Install the rear manifold runner only. Route the crankcase hoses and install the throttle body heater hoses.





5. Install the intake manifold plenum and install the intake plenum bolts.
6. Install the plenum bolts.
^ Tighten the intake plenum bolts to 8 Nm (71 inch lbs.).





7. Install the front manifold runner and tighten the clamps.
8. Install the front manifold runner bolts.
^ Tighten the intake manifold runner bolts to 8 Nm (71 inch lbs.).