Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Shift Cable: Service and Repair

Automatic Transmission Range Selector Cable Lever Replacement

- Tools Required
- J 36346 Fascia Retainer Remover

Removal Procedure

Notice: The control cable must be disconnected from the transaxle range switch lever prior to disconnecting it from the control cable bracket. Otherwise damage to the manual shift shaft may result, requiring transaxle disassembly.

1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the left splash shield.
4. Remove the range selective lever bolt and cover.
5. Using the J 36346, disconnect the control cable from the transaxle range switch lever.





6. Remove the transaxle range switch lever nut (4), lock nut (3), washer (2), and lever (1).

Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the transaxle range switch lever (1), washer (2) lock washer (3), and lever nut (4).
- Tighten the transaxle range switch lever nut to 16 Nm (12 ft. lbs.).
2. Snap the cable end fitting onto the ball stud of the transaxle range switch lever. An audible snap will be heard when properly installed.
3. Install the battery tray and bracket.
4. Install the battery.
5. Install the range selective lever bolt and cover.
- Tighten the bolt to 10 Nm (89 inch lbs.).
6. Install the left splash shield.
7. Install the tire and wheel.
8. Lower the vehicle.