Regulator Valve Body Assembly Installation

Regulator Valve Body Assembly Installation





1. Install the spacer plate locating pins (401) into the control valve body assembly (250).
2. Install the regulator body spacer plate (400).
3. Lubricate and install a new stator shaft O-ring seal (406) on the stator shaft and torque arm assembly (431).
4. Install the stator shaft and torque arm assembly (431) through the hole located in the control valve body assembly (250). Ensure that the assembly is fully seated and moves freely.





5. Insert the 7 x 71 mm stator shaft stop pin (405) into the hole located in the control valve body assembly (250).
^ Ensure that the pin bottoms out in the hole located in the torque converter housing assembly (150).
^ Position the torque arm assembly to allow the pin to be positioned between the stops.





6. Install the regulator valve body assembly (430) onto the control valve body assembly.
7. Install the following regulator valve body bolts:
^ 2 M6 x 1.0 x 35 mm bolts (411)
^ A M6 x 1.0 x 55 mm bolt (412)
^ 4 M6 x 1.0 x 70 mm bolts (413)
^ A M6 x 1.0 x 80 mm bolt (414)





Notice: Refer to Fastener Notice in Service Precautions.

8. Tighten the bolts in the sequence shown.
^ Tighten all bolts to 12 Nm (106 inch lbs.).