Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the engine wiring harness electrical connector (2) from the crankshaft position (CKP) sensor.




3. Remove the CKP sensor stud.
4. Remove the CKP sensor.

Installation Procedure




1. Lubricate the CKP sensor O-ring with clean engine oil.
2. Remove the CKP sensor.

Notice: Refer to Fastener Notice.

3. Remove the CKP sensor stud.

Tighten the stud to 10 N.m (89 lb in).




4. Connect the engine wiring harness electrical connector (2) to the CKP sensor.
5. Lower the vehicle.
6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn. Service and Repair