Rear Side Door Window Replacement

Rear Side Door Window Replacement

Removal Procedure

1. Remove the door trim panel.
2. Remove enough of the door water deflector in order to access the door window to regulator bolts.




3. Connect the power window switch and open the rear door window until you can access the window bolts through the inner access holes.
4. Remove the door window frame applique.
5. Remove the outer belt seal.
6. Disengage the window from the run channels.
7. Remove the window to sash bolts.
8. Remove the window from the door.

Installation Procedure




1. Install the rear side door window in the door.
2. Engage the window in the run channels.
3. Install the outer belt seal.
4. Install the door window frame applique.
5. Slide the window to the full up position and tape the window in place.
6. Connect the power window switch and move the window regulator to gain access to the window bolts through the inner panel.
7. Lower the window and attach the window to the regulator.

Notice: Refer to Fastener Notice.

8. Install the bolts.

Tighten the bolts to 10 N.m (89 lb in).

9. Install the door water deflector.
10. Install the door trim panel.