License Plate Bracket: Service and Repair

Front License Plate Bracket Replacement

Removal Procedure




1. Remove the license plate screws and the license plate.
2. Remove the rivets attaching the license plate bracket to the front fascia.

Installation Procedure

1. If this is a first-time installation, complete the following steps:
1. Install a drill stop on a 5-mm (13/64-in) drill bit in order to ensure that the bit does not penetrate the front fascia more than 13 mm (0.5 in).
2. Using a license plate bracket as a template, drill 2 5-mm (13/64-in) middle mounting holes through the front fascia.
3. Install the rivets in the 2 middle mounting holes of the license plate bracket.
4. Using a license plate bracket as a template, drill 1 5-mm (13/64-in) upper mounting hole through the front fascia.




2. Install the rivets in the upper mounting hole of the license plate bracket.
3. Position the license plate to the bracket. Install the license plate retaining screws.