Body Control Module Programming and Setup

Body Control Module Programming and Setup

Each of the following courses of action requires a setup or programming procedure before the body control module (BCM) can be put into normal service.

Body Control Module (BCM) Replacement

If the BCM is replaced, the following procedures must be performed in the subsequent order:

* BCM Reprogramming-Refer to Programming and Relearning Programming and Relearning
* Theft Learn-Refer to Programming Immobilizer System Components. Programming and Relearning

Sensing and Diagnostic Module (SDM) Replacement

If the sensing and diagnostic module (SDM) is replaced, the following procedures must be performed:

* BCM Reprogramming-Refer to Programming and Relearning Programming and Relearning
* Theft Learn-Refer to Programming Immobilizer System Components. Programming and Relearning

Ignition Switch Replacement

If the ignition switch is replaced the following procedures must be performed:

* BCM Reprogramming-Refer to Programming and Relearning Programming and Relearning
* Theft Learn-Refer to Programming Immobilizer System Components. Programming and Relearning

Body Control Module (BCM) Reprogramming

If the BCM is reprogrammed, the following procedures must be performed:

* BCM Reprogramming-Refer to Programming and Relearning Programming and Relearning
* Theft Learn-Refer to Programming Immobilizer System Components. Programming and Relearning

Theft Deterrent Programming

If the BCM or the powertrain control module (PCM) is replaced the programming for the replaced module must be performed before the programming of the theft deterrent system. Refer to the following:

* BCM Reprogramming-Refer to Programming and Relearning Programming and Relearning.
* PCM Reprogramming-Refer to Programming and Relearning Programming and Relearning