Rear Wheel Speed Sensor Replacement

Rear Wheel Speed Sensor Replacement

Removal Procedure

Caution: Refer to Brake Dust Caution.




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Disconnect the wheel speed sensor electrical connector (1).
4. Release the wheel speed sensor wire harness grommet (2) from the lower control arm bracket.
5. Release the wheel speed sensor wire harness routing clips (3) from the upper suspension link.




6. Release the wheel speed sensor wire harness routing clips from the upper suspension link.

Important: Clean the wheel speed sensor mounting area on the wheel knuckle of any accumulated dirt and debris.




7. Remove the wheel speed sensor bolt.
8. Pull the wheel speed sensor straight up and out of the wheel knuckle.

Installation Procedure




1. Install the wheel speed sensor to the wheel knuckle.

Notice: Refer to Fastener Notice.

2. Install the wheel speed sensor bolt.

Tighten the bolt to 6 N.m (53 lb in).




3. Install the wheel speed sensor wire harness routing clips to the upper suspension link.




4. Install the wheel speed sensor wire harness routing clips (3) to the upper suspension link.
5. Install the wheel speed sensor wire harness grommet (2) to the lower control arm bracket.
6. Connect the wheel speed sensor electrical connector (1).
7. Install the tire and wheel assembly.
8. Perform the Diagnostic System Check - Vehicle. Initial Inspection and Diagnostic Overview