Removal and Replacement

Rear Differential Clutch Control Module Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the propeller shaft assembly.




3. Remove the torque tube mounting bolt.





Important: DO NOT allow the torque tube to hang, support with a suit stand.

4. Lower the torque tube to gain access to the clutch control module.




5. Disconnect the electrical connectors from the clutch control module.




6. Remove the screws for the clutch control module.
7. Remove the clutch control module from the torque tube.

Installation Procedure




1. Position the clutch control module on the torque tube.

Notice: Refer to Fastener Notice.

2. Install the mounting screws for the clutch control module.

Tighten the screws to 10 N.m (88 lb in).




3. Reconnect the electrical connectors for the clutch control module.




4. Lift the torque back into position.




5. Install the torque tube mounting bolt.

Tighten the bolt to 50 N.m (37 lb ft).

6. Install the propeller shaft.
7. Remove the support and lower the vehicle.
8. Reprogram the clutch control module. Refer to Rear Differential Clutch Control Module Calibration.