Operation CHARM: Car repair manuals for everyone.
Home >> Saturn >> 2007 >> RELAY AWD V6-3.9L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Knock Sensor >> Service and Repair >> Knock Sensor Replacement - Bank 2
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Knock Sensor Replacement - Bank 2



Knock Sensor Replacement - Bank 2

Removal Procedure




1. Remove the right front tire and wheel.
2. Remove the splash shield.
3. Disconnect the engine harness electrical connector (1) from the knock sensor.




4. Loosen and remove the bank 2 knock sensor (2).

Installation Procedure

Important: DO NOT apply thread sealant to the sensor threads. The sensor threads are coated at the factory. Applying additional sealant affects the sensors ability to detect detonation.






Notice: Refer to Fastener Notice.

1. Install and tighten the bank 2 knock sensor (2).

Tighten the sensor to 25 N.m (18 lb ft).




2. Connect the engine harness electrical connector (1) to the knock sensor.
3. Install the splash shield.
4. Install the right front tire and wheel.
pro multis · About Operation CHARM