Parking Assist Control Module: Service and Repair

Object Alarm Module Replacement

Removal Procedure




1. Remove the right rear compartment side trim.
2. Disconnect the electrical connector from the rear object detection module.
3. Remove the mounting bolts from the rear object detection module.
4. Remove the rear object detection module from the vehicle.

Installation Procedure




1. Align the rear object detection module to the vehicle.

Notice: Refer to Fastener Notice.

2. Install the rear object detection module mounting bolts.

Tighten the bolts to 10 N.m (89 lb in).

3. Install the electrical connector to the rear object detection module and press in the locking tab.
4. Install the rear compartment side trim.
5. For programming and setup information. Refer to Programming and Relearning Programming and Relearning