Operation CHARM: Car repair manuals for everyone.
Home >> Saturn >> 2007 >> RELAY AWD V6-3.9L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Body Control Module >> Service and Repair >> Removal and Replacement >> Front Door Module Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front Door Module Replacement



Front Door Module Replacement

Removal Procedure

1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the front door speaker.
4. Disconnect the door wiring harness from the body harness.
5. Disconnect the sash from the glass by squeezing the tabs on both of the glass attachment clips at the same time. With the tabs pressed down, slide the sash in the direction of the snap tabs until the sash clips clear the glass attachment clips.




6. Slide the glass (1) full up and tape in place to the door window frame (2).




7. Remove the 3 door to latch (2) screws.
8. Remove the outside handle from the door, including the disconnecting rod.




9. Pull the door harness through hinge face into door cavity and remove the door module (6 screws total).

Installation Procedure




1. Position the front door hardware module to the front door.
2. Align the modular locator pin (1) into the 4-way locating hole (2) in the door structure.

Notice: Refer to Fastener Notice.

3. Install the front door module screws.

Tighten the screws, as shown, to 10 N.m (89 lb in).




4. Install the 3 (1) door to latch (2) screws.

Tighten the screws, in sequence as shown, to 10 N.m (89 lb in).

5. Install the outside handle including the rod connect. Refer to Front Side Door Outside Handle Replacement.
6. Remove the tape on the glass and install the glass to the door module sash.
7. Load the door wiring harness through the hinge face and attach to the body harness.
8. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement.
9. Install the front door speaker. Refer to Radio Front Speaker Replacement.
10. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement.
pro multis · About Operation CHARM