Quarter Window Replacement (With A20 Power)

Quarter Window Replacement (With A20 Power)

Removal Procedure





Important: Before removing a stationary window, apply a layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.

1. Remove the body side rear upper finish panel.
2. Remove the rear corner upper finish panel.
3. Open the bodyside window to the full open position.
4. Disconnect the electrical connector (4) from the power window actuator (5).
5. Disconnect the actuator arm from the rear window hinge.
6. Remove the bodyside window hinge nuts (2).
7. Remove the bodyside window (1) from the opening.
8. Inspect the quarter window weatherstrip. Replace the weatherstrip, if damaged. Refer to Rear Quarter Window Weatherstrip Replacement.
9. Remove the hinge screw (3) from the window (1).

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the bodyside window hinge screw (3) to the window (1).

Tighten the screw (3) to 1.6 N.m (1.4 lb in).

2. Install the bodyside window to the bodyside opening.
3. Install the bodyside window hinge nuts (2).

Tighten the nuts (2) to 10 N.m (89 lb in).

4. Secure the window hinge to the actuator arm.
5. Connect the electrical connector (4) to the power window actuator (5).
6. Inspect the bodyside window for proper operation.
7. Close the bodyside window.
8. Remove the masking tape from around the perimeter of the painted surfaces and inner trim of the window.
9. Install the rear corner upper finish panel. Refer to Upper Rear Trim Finish Panel Replacement.
10. Install the body side rear upper finish panel. Refer to Body Lock Pillar Upper Trim Panel Replacement.