Wiper Motor Replacement

Wiper Motor Replacement

Tools Required

J 39529 Wiper Linkage Installer

Removal Procedure




1. Position the wipers in the parked position.




2. Disconnect the wiper motor electrical connector.
3. Remove the wiper motor crank arm nut (4) and crank arm (5).
4. Remove the wiper motor screws (3).
5. Remove the wiper motor from the module assembly.

Installation Procedure





Important: A new wiper motor will be shipped in the parked position.

1. Position the crank arm (5) to the wiper motor pivot shaft. Ensure the arm resides between the 2 casting dimples (2) as shown.

Notice: Refer to Fastener Notice.

2. Install the crank arm pivot nut (4).

Tighten the pivot nut to 10 N.m (89 lb in).

3. Using the J 39529, secure the transmission link (1) to the wiper crank arm (5).




4. Position the module assembly to the lower plenum. Refer to Wiper Motor Module Replacement.




5. Connect the electrical connector (2) to the wiper motor (1).
6. Reposition the wiper arms.
7. Inspect the front wiper system operation.