Trunk / Liftgate Handle: Service and Repair

Liftgate Outside Handle Replacement

Removal Procedure




1. Open the liftgate.
2. Remove the liftgate trim panel.
3. Remove the lock cylinder.
4. Disconnect the outside handle swing over clip from the outside handle rod.
5. Remove the liftgate outside handle bolts.
6. Remove the liftgate handle from the liftgate.

Installation Procedure




1. Position the liftgate handle to the liftgate.

Notice: Refer to Fastener Notice.

2. Install the bolts to the liftgate handle.

Tighten the liftgate handle bolts to 4 N.m (35 lb in).

3. Reconnect the outside handle swing over clip to the outside handle rod.
4. Install the lock cylinder.
5. Install the liftgate trim panel.
6. Close the liftgate.