Speed Sensor Front
SPEED SENSOR FRONT LHREPLACEMENT
HINT: Overhaul the RH following the same procedures as for the LH.
1. REMOVE FRONT WHEEL
2. REMOVE BATTERY
3. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the speed sensor connector.
b. Remove the 2 clamp bolts holding the speed sensor wire harness from the body and the shock absorber.
c. Disconnect the resin clip and the speed sensor wire harness from the shock absorber.
d. Remove the bolt and the speed sensor front LH.
NOTICE: Prevent foreign matter from attaching to the sensor tip.
4. INSTALL SPEED SENSOR FRONT LH
a. Install the speed sensor front LH with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: Prevent foreign matter from attaching to the sensor tip.
b. Install the speed sensor wire harness with the 2 bolts on the body and the shock absorber.
Torque:
Bolt A: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
Bolt B: 29 Nm (300 kgf-cm, 21 ft. lbs.)
NOTICE: Do not twist the sensor wire when installing the sensor.
c. Connect the resin clip and the speed sensor wire harness to the shock absorber.
d. Connect the speed sensor connector.
5. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
6. INSTALL BATTERY
7. CHECK ABS SPEED SENSOR SIGNAL
Refer to Antilock Brakes / Traction Control Systems; Testing and Inspection.