Camshaft Bearing
Service DataCamshaft bearing cap setting ring pin protrusion height 8.5 to 9.5 mm (0.335 to 0.374 inch)
Camshaft bearing cap No.2 x Cylinder head sub-assy 13 Nm (129 kgf-cm, 9.4 ft. lbs.)
Camshaft bearing cap No. 1 x Cylinder head sub-assy 23 Nm (235 kgf-cm, 17 ft. lbs.)
Tightening Specifications
CAMSHAFT
a. Apply a light coat of engine oil on the camshaft journals.
b. Place the camshaft on the cylinder head with the timing mark on the camshaft timing gear facing upward.
c. Examine the front marks and numbers and tighten the bolts in the sequence shown in the illustration.
Torque: 13 Nm (129 kgf-cm, 9.4 ft. lbs.)
NOTICE: Tighten each bolt uniformly keeping the camshaft level.
NO.2 CAMSHAFT
a. Apply a light coat of engine oil on the camshaft journals.
b. Place the camshaft on the cylinder head with the timing mark on the camshaft timing gear facing upward.
c. Examine the front marks and numbers and tighten the bolts in the sequence shown in the illustration.
Torque: 13 Nm (129 kgf-cm, 9.4 ft. lbs.)
NOTICE: Tighten each bolt uniformly keeping the camshaft level.
d. Install the bearing cap No.1.
Torque: 23 Nm (235 kgf-cm, 17 ft. lbs.)