Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2006 >> xA L4-1.5L (1NZ-FE) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Sensors and Switches - Computers and Control Systems >> Coolant Temperature Sensor/Switch (For Computer) >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Coolant Temperature Sensor/Switch (For Computer): Service and Repair

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE AIR CLEANER ASSEMBLY




3. DISCONNECT ENGINE WIRE
a. Disconnect the 2 clamps of the engine wire.

4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR




a. Disconnect the sensor connector.




b. Remove the sensor and gasket.

INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
a. Install a new gasket to the sensor.




b. Install the sensor.

Torque: 20 N.m (204 kgf.cm, 15 ft.lbf)




c. Connect the sensor connector.




2. CONNECT ENGINE WIRE
a. Connect the 2 clamps of the engine wire.

3. INSTALL AIR CLEANER ASSEMBLY
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
pro multis · About Operation CHARM