Installation

SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION ECU: INSTALLATION

INSTALLATION

1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Check that the ignition switch is in the OFF position.
(b) Check that the negative battery (-) cable is disconnected.
CAUTION: Work must be started at least 90 seconds after the ignition switch is turned off and after the cable is disconnected from the negative (-) battery terminal.

(c) Install the occupant classification ECU.
(d) Connect the connectors to the occupant classification ECU.
NOTICE:
- If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.
- When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

2. INSTALL FRONT SEAT ASSEMBLY RH
HINT: Refer to the procedures up to "INSTALL FRONT SEAT ASSEMBLY" Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
(a) Perform initialization Testing and Inspection.
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.

5. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
(a) Perform zero point calibration and sensitivity check Programming and Relearning.
6. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.