Installation

HEATING / AIR CONDITIONING: BLOWER RESISTOR: INSTALLATION

1. INSTALL BLOWER RESISTOR

(a) Install the blower resistor with the 2 screws.

(b) Connect the connector.

2. INSTALL LOWER INSTRUMENT PANEL Installation

3. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY Installation

4. INSTALL INSTRUMENT CLUSTER FINISH NO. 1 PANEL Installation

5. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY Installation

6. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

7. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

8. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY Installation

9. INSTALL COWL SIDE TRIM BOARD RH Installation

10. INSTALL COWL SIDE TRIM BOARD LH

HINT
Use the same procedure as for the RH side.

11. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

(a) Install the front door opening trim weatherstrip.

12. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

(a) Install the front door opening trim weatherstrip.

13. INSTALL FRONT DOOR SCUFF PLATE RH Installation

14. INSTALL FRONT DOOR SCUFF PLATE LH

HINT
Use the same procedure as for the RH side.

15. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

16. INSTALL FRONT CONSOLE BOX COVER Installation

17. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

18. INSTALL CONSOLE UPPER PANEL SUB-ASSEMBLY Installation

19. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

20. INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL Installation

21. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Installation

22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

23. INSPECT SRS WARNING LIGHT

Diagnosis System