Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2012 >> xB L4-2.4L (2AZ-FE) >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Restraints and Safety Systems >> Seat Occupant Classification Module - Air Bag >> Service and Repair >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation





SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION ECU: INSTALLATION

NOTICE:
* Never use SRS parts from another vehicle. When replacing the parts, replace them with new ones.
* Never reuse an occupant classification ECU involved in a collision when the airbag has deployed.
* If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the occupant classification ECU, make sure that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
* After installing, shake the occupant classification ECU to check that there is no looseness.
* Remove the front seat cushion cover pad and front seat cushion cover together, in order to avoid occupant classification sensor malfunctions.

1. INSTALL OCCUPANT CLASSIFICATION ECU

(a) Check that the ignition switch is OFF.





(b) Check that the negative battery (-) terminal is disconnected.

CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Install the occupant classification ECU with the 2 bolts.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(d) Connect the connector to the occupant classification ECU.

NOTICE:
* If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the occupant classification ECU, make sure that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
* When replacing the occupant classification ECU, replace the bolt with a new one.

2. INSTALL FRONT SEAT ASSEMBLY RH Installation

3. INSTALL SEAT TRACK INNER BRACKET COVER Installation

4. INSTALL SEAT TRACK COVER Installation

5. INSTALL FRONT SEAT HEADREST ASSEMBLY

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

7. INSERT OCCUPANT CLASSIFICATION ECU DATA Registration

8. PERFORM ZERO POINT CALIBRATION AND
SENSITIVITY CHECK

Initialization

9. INSPECT SRS WARNING LIGHT

Diagnosis System
pro multis · About Operation CHARM