Registration

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM: REGISTRATION; 2013 MY FR-S [03/2012 -]

HINT
* Register the recognition code when replacing the door control transmitter or the door control receiver.
* The Add mode is used to retain the already registered codes while registering a new recognition codes. This mode is used when adding a transmitter. If the number of registered codes exceeds 7 the previously registered code will be cleared in order, starting from the code registered first.
* Rewrite mode is used to clear all the previously registered codes and register only new recognition codes. This mode is used when exchanging the transmitter or the door control receiver for new one.
* Confirmation mode is used to confirm how many recognition codes have already been registered before an additional registration of a recognition code.
* Prohibition mode is used to clear all the registered codes and cancel the wireless door lock function. Use this mode when the transmitter is lost.
* All of the following registration procedures must be performed in order.

1. REGISTRATION OF RECOGNITION CODE (USING TECHSTREAM)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Utility / Wireless Code Registration.

(e) Press both lock and unlock switches within 1 to 1.5 seconds.

(f) Press either switch for more than 1 second within 3 seconds.

(g) Perform either of the following to complete the registration of recognition codes:

* Use a Techstream to send a completion command.

* Disconnect the Techstream.

(h) Perform the following after registration is completed.

(1) Perform the wireless door lock control operation check Operation Check.

HINT
If the wireless door lock control does not operate, perform the registration procedure again.