Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: BRAKE ACTUATOR: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL BRAKE ACTUATOR ASSEMBLY WITH BRAKE ACTUATOR BRACKET

(a) Install the brake actuator assembly with brake actuator bracket using the 4 bolts.

Torque : 33 Nm (338 kgf-cm, 24 ft-lbf)

(b) Connect the brake actuator connector to the brake actuator.

(c) Turn the locking lever downwards, and engage the wire harness connector locking claw to lock the connector.









NOTICE:
* Make sure that the actuator connector can be connected smoothly. Do not allow water, oil or dirt to enter.
* Make sure that the connector is locked securely.

(d) Using a union nut wrench 12 mm, tighten 2 brake tubes.





Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)

NOTICE:
Use the formula to calculate the special torque values for situations where the union nut wrench is combined with a torque wrench Service Precautions.

(e) Using a union nut wrench 10 mm, tighten the 4 brake tubes.





Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
Use the formula to calculate the special torque values for situations where the union nut wrench is combined with a torque wrench Service Precautions.

(f) Connect the front speed sensor LH harness clamp to the brake actuator bracket assembly.

(g) Connect the cooler pipe to the clamp.

(h) Connect the 2 harness clamp to the brake actuator bracket.

2. ADD BRAKE FLUID Service and Repair

3. BLEED BRAKE SYSTEM

Service and Repair

4. INSPECT FLUID LEAK

5. INSPECT BRAKE FLUID LEVEL Testing and Inspection

6. INSTALL FRONT FENDER LINER LH Installation

7. INSTALL FRONT WHEEL LH

Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)

8. VSC SENSOR NEUTRAL MEMORIZATION

Programming and Relearning

9. INSPECT SPEED SENSOR

Test Mode Procedure